U-shaped car wiper interface
The wiper arm of this interface is a traditional style with strong uniformity. As long as the wiper you buy has a U-shaped mouth, it can be installed. However, the replacement method of this type of wiper is relatively old today, and the installation method is not so user-friendly. . This type of wiper is commonly found on low-end and mid-range models, mainly with bone wipers.
When disassembling, you need to push the universal wiper blade to the root of the wiper arm first, and then pull it out in the opposite direction after it is detached from the wiper arm interface. Rotate the bar a bit, otherwise it will be blocked when pulled out. It should be noted here that there are many wipers that will be very tight when disassembled. At this time, we cannot use too much force, otherwise it is easy to hurt the wiper interface and our hands.
Plug-in car wiper interface
This kind of wiper interface is to insert the wiper directly into the wiper arm, and lock it by the locking block. The method to identify this type of interface is very simple, just observe whether there is a "small button" on the wiper arm. When replacing, we use one hand to press the small button on the wiper arm to the end, so that the wiper can move, and the other hand pulls the wiper out to remove the wiper. Installation is easier, just insert the new wiper directly into the wiper arm.
The fixing method of this type of wiper is similar to the previous one, but the lock button is not on the top of the wiper arm, but on both sides. When removing, you need to press the lock button on both sides of the wiper with one hand at the same time, and the other hand will wipe the wiper. Pull it out. However, the alignment of this structure will be awkward during installation. Do not use too much force, otherwise the wiper interface will be injured.
The above two types of wiper arm interface are mostly found in Japanese, Korean and American cars.
This type of wiper is very recognizable from the appearance. The link between the wiper arm and the wiper seems to fall together in two layers. I personally think that this type of wiper is easy to replace. After erecting the wiper arm, rotate the wiper to a state perpendicular to the wiper arm, and then the wiper can be removed from the wiper arm without touching any locking device. This type of wiper arm is often found on European models, and Fox uses this type of wiper arm.
PREV:Glass water is good for protecting car wipers NEXT:What are the reasons for the failure of wiper blades